Step 1: Prepare Surface Edge
- Fill any large holes
- Sand rough spots
- Remove sawdust
- Cut edging 1.5cm longer than surface to be covered
Step 2: Apply Edging
- Preheat iron on “cotton” setting
- Position edging
- Slowly press iron over length of edging
- Check to see if glue is melting
NOTE: Use craft paper or aluminium foil to protect iron bottom.
Step 3: Bonding
- Whilst still hot, press edging down firmly with wood block or roller
- If mistakes should occur, simply reheat and reapply
Step 4: Trim Edge
- Allow edging to cool completely
- Trim excess with an edge trimmer or utility knife
- Sand wood veneer smooth and finish as desired
